Time for some paint

Decided to get off my backside and take the boat back to the workshop today. Bodywork/paint isn’t my speciality and its so messy, but has to get done.

So with the back end of the boat stuffed in the workshop I started to sand back all the primer from the last coat, and to make the cuts less obvious. I was genuinely daunted by this. It seemed an impossible task with such an obvious cut and slight imperfections where the two top halves now joined. I decided just to be patient and see what I could do. Fortunately filler goes off quite quickly so if I had made any mistakes I could just start again until I was happy.

So after a few hours of sanding filling then repeat, I had it at a point where it looked like this:

Image
Image
Image

I decided enough and, so now to clean and prepare for the top coat, 1 litre of sprayed paint later:

Image

Image

Amazing, It actually looks really good. Sure its not perfect, but its good enough that I’m happy with it. I don’t yet know how well it will blend from gelcoat to paint, but hopefully with polishing that will be fine. If all else fails I’ll paint the rest of the top half.

So the bits that really bothered me i.e. the cuts, also came out ok. I took some close ups, see what you think:

The join is where the metal strip ends… You can see my shadow in this, that’s not in the finish
Image
Again.. The join is where the metal strip ends…
Image

And finally the pic of what started this in the first place:
Image

I have a couple of minor runs to deal with, only 3 I think which isn’t bad considering, but for now I need to let the paint harden for a while now, I’m slightly worried that the cover is to heavy and abrasive that it may damage the paint so I’m going to see if I can leave it undercover for a week to let it fully cure, that will help.

So I’m nearly onto the next stage, I can’t wait!!! I’ll fit a new bung and motor well drain as well as a few other bits. Then I’ll start to work on the inside of the boat, this is the bit I enjoy most out of the water I think. I really can’t wait to get all the audio/engine/wiring etc on this – Exciting times ahead!!

Leave a Reply

Your email address will not be published. Required fields are marked *